In a busy laundry room, every out-of-order machine is a financial leak. But too often, operators and techs go straight for the mechanical parts—valves, belts, pumps—when the real issue is electronic.
Knowing the difference between a mechanical failure and a control board fault can save you thousands of dollars and days of downtime.
Mechanical failures usually make noise — grinding, thumping, squealing, or rattling.
Electronic failures are silent — the machine simply does nothing, stalls mid-cycle, or behaves inconsistently.
If you hear the machine trying to run but struggling, it’s mechanical. If it sits there quietly ignoring commands, it’s probably electrical.
Mechanical issue indicators: Machine powers on normally, but water, spin, or heat functions misbehave.
Electronic issue indicators: Lights flicker, the display goes blank, or shows communication errors like “No Comm”, “E01”, or “Door Lock Fault.”
When a machine’s interface locks up, restarts, or randomly clears settings, that’s a clear sign of control logic trouble.
Mechanical issues usually show gradual decline — a pump getting louder, a dryer taking longer to heat.
Electronic issues appear suddenly — one day it’s fine, the next day dead.
If the failure appeared out of nowhere, suspect the control board first.
A simple test:
If you have power to the board but no output from it — the board is the problem.
If no power reaches the board, check fuses, breakers, and plugs.
This 60-second check can prevent replacing perfectly good motors, valves, or belts.
| Symptom | Likely Cause | Category |
|---|---|---|
| Drum won’t spin, motor hums | Seized motor bearings or belt slip | Mechanical |
| Drum won’t spin, no sound | Inverter or VFD board failure | Electronic |
| Machine won’t start at all | Failed power relay or main control board | Electronic |
| Machine fills endlessly | Pressure hose leak or stuck valve | Mechanical |
| Dryer spins but no heat | Heat control or ignition board fault | Electronic |
| Washer drains continuously | Logic signal stuck high on control board | Electronic |
If your test shows power entering the board but nothing leaving, or if the problem persists after replacing sensors and motors, don’t waste money on new assemblies.
UpFix can bench-test your control board and confirm the fault before you spend hundreds unnecessarily. If the board is bad, we’ll repair it, test it, and ship it back ready to plug in—usually within 48 hours.
Replacing a working motor or pump when the board was bad costs hundreds. Replacing a working board when a pump was clogged costs just as much. Knowing the difference helps operators and technicians diagnose faster, save money, and keep machines online.
Get expert help before replacing parts blindly.
Send your control board to UpFix for diagnostic testing and professional repair.
We’ll confirm the cause, restore full functionality, and help you keep your laundry equipment earning instead of idling.