Commercial Laundry Electronics Repair Services | UpFix

Running a laundromat or laundry facility is tough business. Every dollar counts—and when machines stop spinning, profits stop too. UpFix helps you repair, not replace, expensive control and drive systems fast.

Top 12 Commercial Laundry Electronics Problems We Repair

1. Main Control Board Failure – Washer Won’t Start or Stuck Mid-Cycle

The brain of your machine. When the main logic board fails, cycles freeze, start buttons do nothing, and revenue stops. UpFix repairs power and logic faults at the component level—no reprogramming, no wasted money.

2. Motor Control / Inverter or Delta VFD Failure – Drum Won’t Spin or Overcurrent Faults

A failed inverter or drive circuit leaves your drum motionless or jerky. We rebuild drive transistors, regulators, and Delta VFD modules (VFD-M, VFD-E, VFD-B) to restore smooth, efficient spin control.

3. Door Lock / Interlock Board Failure – Machine Won’t Start or Unlock

Faulty interlock boards cause safety lockouts and endless “door” errors. We repair burned relays and corroded traces so your customers can load, run, and unload without delays.

4. Dryer Ignition or Heat Control Faults – No Heat or Ignition Lockout

When dryers tumble cold or lock out after ignition attempts, the heat-control board is usually the culprit. UpFix restores ignition relays, regulators, and flame-sensor circuits for reliable drying performance.

5. User Interface / Display Panel Failure – Dead or Flickering Display

Customers assume a dark screen means “out of order.” We replace voltage regulators, LCD drivers, and keypad matrix contacts so your interface looks—and works—like new.

6. Coin Acceptor / Card Reader Board Faults – Payment System Offline

If coins or cards don’t register, your profits stop. UpFix repairs and calibrates coin and digital payment boards (CCI, ESD, Nayax, Speed Queen Insights and more) so every payment counts again.

7. Water Level / Pressure Sensor Board Failure – Overfilling or Underfilling

Over- or under-filling wastes water, detergent, and time. We repair pressure sensor circuits, converters, and regulators to restore precise fill control and lower your water bills.

8. Drain Pump Control Board Faults – Won’t Drain or Error Mid-Cycle

If the washer stalls full of water, the pump driver or relay is often burned out. UpFix rebuilds power paths and protection circuits so your washers drain properly and stay online.

9. Temperature Sensor / Thermistor Board Failure – Erratic Temperature

Inconsistent heat leads to poor results and angry customers. Our technicians restore thermistor circuits and heat-control relays for accurate, energy-efficient temperature regulation.

10. Communication Loss Between Boards – “No Response” or “ECOMM” Errors

When system boards stop talking, the entire machine fails. We replace damaged transceivers, rebuild connectors, and test signal integrity so every module stays in sync.

11. Power Supply / Relay Board Failure – Blown Fuses or Random Resets

Power instability can kill profits. UpFix repairs regulators, fuses, and relay drivers, restoring consistent voltage and protecting your equipment from future surges.

12. Delta or Industrial VFD Drive Failure – Overcurrent, Overvoltage, or “OC/OV” Fault Codes

VFDs control motor torque and speed. When they fail, machines stop spinning entirely. UpFix rebuilds Delta VFD-M, VFD-E, VFD-B, Lenze, Invertek, Yaskawa, and ABB drives—restoring performance, saving thousands, and preventing unnecessary replacements.

Delta VFD Integration – Detailed Focus

Common Delta Drive Faults We Repair

UpFix performs IGBT replacement, driver IC testing, capacitor renewal, and firmware-safe EEPROM reprogramming, followed by full-load simulation on Delta VFD test benches.
Each repaired drive is returned plug-and-play ready, backed by professional diagnostics.

Why Laundry Operators Choose UpFix

• Up to 80 percent savings compared with OEM replacement

• 24-to-48-hour turnaround on most control and drive repairs

• Plug-and-play reinstall—no programming required

• Environmentally responsible: every repair keeps electronics out of landfills

• Trusted nationwide by laundromats, hotels, and commercial laundry facilities

Get Back to Earning Fast

When machines stop spinning, profits stop too.
Send your part to UpFix for expert diagnostics and repair.
We’ll restore performance, save you money, and keep your washers and dryers running strong—so your business never skips a cycle.